0item(s)

You have no items in your shopping basket.

Product was successfully added to your shopping cart.

How To Install Electric Underfloor Heating Mat?

How To Install Electric Underfloor Heating Mat 

(PLEASE NOTE - CABLES MUST NEVER TOUCH, OR OVERLAP. CABLES MUST NEVER BE CUT.)

Before laying the Underfloor Heating Express heating mat, test it using a digital multimeter reader. Make a note of the reading. You will test again, during and after installation. (See manual for correct readings based on your mat size. If readings are not the same, please contact us to advise what to do next.)

Your qualified electrician will advise on the best way to connect Underfloor Heating Express heating mat into your RCD unit (Residual Current Device unit), based on your property.

Lay Underfloor Heating Express heating mat out without fixing, to ensure perfect fit and make any adjustments, before permanent installation.

Mats should be laid approx 5 and 10cm away from the wall.

Where there are awkward areas, such as bathroom fittings, remove cable carefully from the mesh. Lay loose cable around the fittings and stick down using duct tape.

Once you are happy with layout and spacing, you can now peel off the double-sided tape on the bottom of the mesh and fix to Underfloor Heating Express XPS board permanently.

Now perform another meter reading using your digital multimeter reader. This should have the same reading as before. If not, please contact us to advise what to do next.